2510/2842 Precision flat steel 500 mm
Precision flat steel
Bearing length: 500mm
100MnCrW4 / 90MnCrV8
Delivery condition: soft annealed 775N/mm² (230HB max.)
Color code 1.2510 Green
Achievable hardness: HRC 61 – 63
Kuvaus
| Tolerance | Surface | |
|---|---|---|
| Thickness +0.05 / 0mm | polished (N7) | Ra 1.6 |
| Width +0.20 / 0mm | pre-ground, finely milled (N8) | Ra 3.2 |
| Length +5 / 0mm | sawn (N15) | Ra 25 |
Material description
The material 1.2510 (in Germany 1.2842) is the most widely used tool steel worldwide. Both materials are considered equivalent in terms of their properties. There are no differences in machinability or dimensional changes after heat treatment. The hardenability-enhancing element manganese (Mn) in 1.2842 is compensated for in 1.2510 by an increased chromium (Cr) content. This is also demonstrated by the time-temperature graphs. Material 1.2510 contains tungsten as an additional carbide former.
This is a positive aspect, however, as it results in higher wear and tempering resistance. Material 1.2842, which was developed from tungsten and chromium deficiency, is largely unknown abroad. With European standardization, material 1.2510 (01) will become the standard. Therefore, 1.2510 can be supplied as 1.2842, but not vice versa.
| L% | C | Si | Mn | Cr | Ni | Mon | W | V | S |
|---|---|---|---|---|---|---|---|---|---|
| 1.2842 | 0.90 | 0.20 | 1.90 | 0.40 | 0.10 | ||||
| 1.2510 | 0.95 | 0.20 | 1.20 | 0.60 | 0.60 | 0.10 |
Lisätiedot
| Paino | Ei saatavilla/-tietoa |
|---|---|
| Mitat | Ei saatavilla/-tietoa |
| Leveys | 4, 5, 6, 7, 8, 10, 12, 15, 16, 18, 20, 23, 25, 30, 35, 40, 45, 50, 60, 70, 75, 80, 90, 100, 120, 125, 150, 160, 180, 200, 250, 300, 405, 505 |
| Korkeus | 1, 1,5, 2, 3, 4, 5, 6, 7, 8, 10, 12, 15, 16, 18, 20, 23, 25, 30, 35, 40, 45, 50, 60, 80 |
| Pituus | 500 |
